• Rise from your gwave!

antime's Recent Activity

  1. antime replied to the thread USB dev cart project.

    You still need to specify the board parameters, but the Seeed Fusion defaults are fine. You can check the parameters from there if you...

    Oct 16, 2018 at 12:16 PM
  2. antime replied to the thread Using CPU-DMAC to transfer via USB cart to PC-side.

    If you write 64 bytes to the FIFO every time TXE goes low, then it will overflow and data will be lost. I implemented an output console...

    Oct 15, 2018
  3. antime replied to the thread Using CPU-DMAC to transfer via USB cart to PC-side.

    One thing to note about the FT245R is that even though it uses 64 byte USB packets in both directions, two bytes of each IN (device to...

    Oct 15, 2018
  4. antime replied to the thread Using CPU-DMAC to transfer via USB cart to PC-side.

    The register controls some access timings. My understanding is as follows: - If the "previous read" bit is set, then after a read...

    Oct 15, 2018