What is a good PCB thickness to not have any issues with height? I was thinking of 0.8mm to keep it low with the IC on top. Do you recommend the typical 1.6mm?
Could you release your schematic files like in the first post even if it is difficult.
Also will the PLCC-32 memory chip be too tall when it is on the PCB and motherboard? I am finding these to be much cheaper in cost than the tsop version of AT29C040A and if they fit without issue I will go...
I did see his video of this and if he releases the info or files like he has I will look into providing this as a complete board. Assuming we can get the required IC.
Just in case anyone is wondering I do plan to give @tzmwx a donation from my sales (once I have these built and working) since...
I waited for quite a few months to see if anyone would pick this up and no one has so I am looking into providing them for people pre-assembled so I will be needing the chips. I ordered some to try out and hopefully they work out, I will post info once I have gotten all parts in.
I am a bit confused about that green wire which I assume is to manually turn it off? Can you explain that wire and how to use the on/off with manual and automatic? This info is not well covered in the original post.
Thanks.
Can other Flash Memory be used? I am looking at other Memory IC that are easier to find like the SST39SF040-55-4C-WHE. Also would you be willing to share the design files or if not could you export the DXF of the PCB with Drill Holes?
Thank you.
Quick question, does this boot without a modchip or boot disc? Can it boot off a stock Saturn? From the videos I have seen from @tzmwx it looks like he goes into the memory menu then exits out and it boots the SD Loader software. I made my own adapter and it is not doing anything like I have...
Thanks for explanation and schematic picture, I only need 1 pcb as of now to see if it will work for what I have in mind. I don't need any components as I can solder those on without issues.
Ok thank you guys for the reply and info. I had an interest in flashing the AR firmware on these but ultimately I don't think there is any cheat tool that used to exist that will interface with the USB. Do you guys know of a way to get it to interface with hacking tools like GSCC2002 without a...
Ok more question, can I use the SST39SF040 in place of the SST39SF010 on your board? I see that the one I want to use has 2 extra address lines A17 and A18 and wondering is it ok to leave them not connected aka floating? or will the have to be tied to ground?
Ah I see, I was unaware that it had been implemented and figured it progressed to the current stage it is in now because of the CD block being dumped. A quick question: What should be the minimum Memory Size for my project 1Megabit?
Well the whole thing behind this is a bootup cart that Cyber Warrior X (he's a member here) coded as a replacement flash update for the AR/GS carts which uses an exploit that was found recently after the CD Block was fully dumped. I hate to ruin the functions of my AR 4+ so I wanted just a...
Ok I decided to go with a 5v tolerant memory IC (MX29F160) and I know I have some errors on the schematic but would need to have them pointed out to me if you could take a look at the schematic I have. Please point out what needs to be fixed or dis/connected, thanks in advance...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.