"Afterburner" GBA Light Kits - Anybody try one yet???
- Thread starter VertigoXX
- Start date
Ya, I was figuring I'd have to set up my "clean room" work table for it. (Small room, BIG dust filter. And if I wanna be really elaborate, I have access to surgeon style face masks and those goofy papery shower cap style things.)
As for the screwdrivers, I'll just do the same as I've done with all the GB colors, GB pockets, and ancient traditional GB's that I've messed with (replacing broken power switches, usualy... once trying to trade the screen from one with a broken switch into one with a busted screen... emphasis on "trying"): Use a small flat head screwdriver to get them out and replace them with phillips head screws.
As for the screwdrivers, I'll just do the same as I've done with all the GB colors, GB pockets, and ancient traditional GB's that I've messed with (replacing broken power switches, usualy... once trying to trade the screen from one with a broken switch into one with a busted screen... emphasis on "trying"): Use a small flat head screwdriver to get them out and replace them with phillips head screws.
Well it finally got here.. It's not like I had to wait too long or anything 🙁. At least it was worth the wait though, it's fantastic. Mine's installed without the dimmer switch because I didn't want to mess the case up, but there's been no point where I would've gained benefit through turning it down. It's actually so good I've used it as a torch on a couple of occasions 🙂.
Only complaint (apart from the wait) is that there are a few specs of dust under the screen.. But that's bairly noticable. I'd highly recommend it if you are confident about the installation.
